Tridox Products | F88 Liquid | F88 Powder

SELF CURING, NON-EPOXY PLASTIC ADHESIVE CEMENT

What is F88?

Industrial Strength Adhesive

F88 is an industrial strength, self curing, non-epoxy plastic adhesive cement. It is a two-part powder and liquid system with a consistent product strength, that requires no pressure or heat to cure.

Unlimited Applications

• ELECTRONICS
• AERONAUTICS
• MARINE FIELD
• MACHINE SHOPS
• MEDICAL FIELD & TEST LABS
• PLASTIC & TOY INDUSTRY
& Much More!

Made To Last

F88 is resistant to most chemicals and it will not shrink or sag over time. The product chemistry makes it have the strongest, long lasting, hold. It will always have consistent product strength regardless of mix ratio.

Simple 3-Step System

Learn More About F88

INSTRUCTIONS FOR USE:

Parts to be filled or joined must be dry, free from oil or grease and unpainted. Remember, the rougher the surface the better the bond.
Mix in a disposable container. (Paper cups suggested.)
Mix for approximately 1 minute. (Should have a cream-like consistency.)
Mix only enough for a single application.
If F88 becomes doughy, DO NOT USE.
With stick or brush apply to parts to be joined or filled. (Always apply in a wet, sticky mix.)
While still soft, remove all excess cement with knife or cloth.
Allow to set without movement until hard.